Lone Star SilencerOutrider
9mm / .36 Cal suppressor · 5/8x24 Direct Thread interface · specs and compatibility from the manufacturer
Notable features
- Multi-Caliber
- Direct Thread
length
9.3″
weight
12oz
length
9.3″
weight
12oz
calibers
5.56–.338+
material
Titanium
interface
5/8x24 Direct Thread
- Overall length
- 9.3″
- Class
- 9mm / .36 Cal
- n
- 202
- Range
- 3.5″–13.7″
- Median
- 6.95″
- Diameter
- 1.5″
- Weight
- 12 oz
- Material
- Grade 5 Titanium (Ti-6Al-4V)
- Finish / treatment
- High-temperature Cerakote
- Max caliber
- .36 Cal
- Base interface
- 5/8x24 Direct Thread
Longer than most 9mm / .36 Cal suppressors
medianTHIS SUPPRESSOR · 9.3″
3.5″13.7″
Length compared against the 202 9mm / .36 Cal suppressors in the catalog that publish one. Quartile basis; a value inside the middle half carries no note.
Not published by the manufacturer: MSRP.
Mount interface: 5/8x24 Direct Thread. It threads straight onto the barrel, so no mount or muzzle device is involved.
Manufacturer claim
- Caliber / Projectile Diameter: Approved for rifle projectiles up to .36 inches in diameter.
- Maximum Cartridge Rating: Rated up to .300 Norma Magnum, including .338 Lapua Magnum, provided projectile diameter does not exceed .36 inches.
- Mounting: Direct-thread only; Thread Pitch: 5/8×24 TPI
- The Outrider's direct-thread design ensures proper bore alignment while minimizing added weight at the muzzle—helping preserve accuracy shot after shot.
Show all 13 ▾ ▴
- Interchangeable .308, .270, and .223 end caps allow you to fine-tune performance while preserving accuracy and balance when the shot matters most.
- Material: Grade 5 titanium (Ti-6Al-4V) construction
- Finish: High-temperature Cerakote (model dependent)
- Firing Schedule: Precision/duty rated; allow adequate cooling during extended firing strings
- Lifetime repair or replacement on defects, damage, or failures. No registration or hoops to jump through—your guarantee is automatic.
- What you should have in the box: Outrider Silencer; Owner's Manual. (No adapters or alternate mounting components are included. The Outrider is direct-thread only.)
- Barrel Restrictions: Minimum 10.5″ barrels for 5.56; Minimum 6″ barrels for .300 Blackout; Minimum 12.5″ barrels for .308; Minimum 18″ barrels for all magnum cartridges
- The Outrider is not HUB compatible and is not designed for quick-detach or secondary mounting systems.
- Do not use ablative media such as water, grease, oil, or gel inside the suppressor. Running the Outrider "wet" is not recommended and may result in unsafe pressure levels, damage to the suppressor, or personal injury.