StingerWorxSuppressor Brake (Titanium)
Front Accessory · attaches to StingerWorx MDS
thread
StingerWorx MDS
material
Titanium
A front cap screws into the front of the suppressor, where the bullet exits. Swapping it lets you match the opening to a smaller caliber for a little more suppression, add a brake or flash-hider function at the front, or replace a damaged cap. It only fits the suppressor line it was made for.
This one fits suppressors that take StingerWorx MDS caps.
Suppressor basics →- Type
- Front Accessory
- Material
- Titanium
- Attaches to
- StingerWorx MDS
Not published by the manufacturer: overall length, weight, MSRP.
Prices are manufacturer's suggested retail (MSRP). What you pay may differ.
- This modular device enhances the muzzle braking efficiency of a StingerWorx suppressor. It replaces the endcap insert of the EVO Ti, EVO Hunter and Venom series suppressors.
- Designed to be indexed on the end of the suppressor so that the ports face upwards for maximum mitigation of recoil, muzzle rise and ground effect. This is done with the lock ring, which also allows for installation of different devices.
- The StingerWorx Modular Device System lets you tune your suppressor on the go: loosen the lock ring and change out the end cap device without uninstalling the suppressor.
- Available in titanium or aluminum; this is the titanium version.
- Choose titanium for hard use on gas guns.
- One size that fits all .30 caliber and smaller.
More in the catalog:All StingerWorx accessories →All front accessories →